Filter
Top Products
Film Loading
-
____-----.--
0
Loading the Film
1. While gently pushing in on the memo
clip (19), move the back cover latch (17)
in the direction of the arrow and the
camera back cover will open.
2. While squeezing in on both sides of
the release latch (37) pull the roll-film
insert out of the camera body. Place
the film insert on a table making sure
that the film type index (42) is not upside
down. Then pull out and lower the
spool clips found on the left-hand side
3. Align the right-hand side of an empty
spool with the lower spool stud (41).
Then return the spool clip (38) to its
former position, making sure that the
left-hand side of the spool is properly
held by the spool clip.
23