Filter
Top Products
Interchanging the Film Advance Crank
with the Shutter release button, by-
passing the delayed shutter release,
as
often as desired
*
If the delayed shutter release is in-
advertently started when the shutter is
uncocked, it will stop after partially
functioning. Then, reset the lever, ad-
vance the film, and push the activating
lever to start the delayed shutter re-
lease. If the film is advanced, at such a
time, before resetting the delayed shut-
ter release,the delayed shutter release
will automatically commence operating
the moment the film is fully advanced,
tripping the shutter a few moments
later.
For the same reasons outlined above,
the shutter release lock ring should
also be set to the unlocked position
before starting the delayed shutter re-
lease.
*When attaching the camera to a
large, professional tripod, the camera
support may protrude beyond the front
of the camera body However, if the
camera is attached to such a tripod
with the accessory Mamiya Quick-shoe
model 2, it will be possible to cock the
delayed shutter release with the cam-
era attached to the tripod.
0 Removing the crank
l
Attaching the crank
1. Rotate the film advance crank until
it stops.
2. Then, rotate it counterclockwise ap-
proximately 20° while simultaneously
pushing in on the release lever (A), and
it will detach.
1. Align the red dot (B) of the camera
body with the index line (C) on the film
advance crank.
2. With red dot and index line aligned,
push the film advance crank into the
receptor, then twist approximately 20°
clockwise while pushing in on the re-
lease lever (A), and it will lock into
place.
53