Filter
Top Products
Menu
105
Item
Display
mode
Description of settings
USER1
P2
TAPE
(Camera) Selects the function assigned to the USER1 button.
REC CHECK:
Performs Rec Check.
SPOTLIGHT:
Auto iris control for the spotlight ON/OFF
BACKLIGHT:
Auto iris control for the backlight compensation (Page 45)
BLACKFADE:
Blackfade (Page 45)
WHITEFADE:
Whitefade (Page 45)
ATW:
ATW function ON/OFF
ATWLOCK:
Fixes the white balance value when the button is pressed during ATW. Press
again to perform ATW.
GAIN: 18 dB:
Press the button to set the gain value to 18 dB. This setting takes effect with
the 60i and 60P recording formats only. It is not valid when the recording
frame rate is less than 22 fps or when the slow shutter mode (1/15) is
established.
• When the gain value is set to 18 dB or set from 18 dB to another value, the
image can be disordered for a moment.
• If the unit is being used in the MANUAL mode or AUTO mode, set the
AGC item on the AUTO SW screen of the setting menu to OFF to use this
function.
FOCUS RING:
Selects the focus ring function (FOCUS or IRIS). The FOCUS RING is
functional when the FOCUS switch is in AUTO mode.
INDEX/MEMO:
Text memo recording (P2 card)(Page 47)/Index recording (cassette tape)
(Page 48)
SLOT SEL (P2 card only):
Selects one of the P2 card slots. (Page 47)
SHOT MARK (P2 card only):
Shot mark recording (Page 47)
USER2
P2
TAPE
(Camera) Selects the function assigned to the USER2 button.
The settings are the same as USER1 above.
BACKLIGHT
USER3
P2
TAPE
(Camera) Selects the function assigned to the USER3 button.
The settings are the same as USER1 above.
INDEX/MEMO
indicates the factory setting.
SW MODE screen (continued)