Filter
Top Products
Preparation
17
Installing and removing the power supply
Installation
Insert the battery until it clicks into place.
Removal
1 Set the POWER switch to OFF, and check
that the mode lamp is off.
2 Remove the battery while pressing the
battery release button.
• Support the battery with your hand to ensure
that it will not fall.
Installation
1 Connect the DC cord to the AC adapter.
2 Plug the AC power supply cord into the
power outlet.
3 Insert the DC cord’s battery connector until
it clicks into place.
Removal
1 Set the POWER switch to OFF, and check
that the mode lamp is off.
2 Remove the DC cord’s battery connector
while pressing the battery release button.
3 Disconnect the AC power supply cord from
the power outlet.
• You cannot charge the battery when supplying
power to the camera-recorder from the AC
adapter.
CAUTION:
• This unit can be operated at a voltage in the
range of 100-240V AC. An AC plug adapter may
be required for voltages other than 120 V AC. If
a conversion plug is required, consult with your
dealer as to which one is to be purchased.
• Disconnect the AC power supply cord from the
power outlet when the unit is not going to be
used.
DC cord’s battery
connector
Battery release
button
Mode lamp
Installing and removing the battery
Connecting and disconnecting the power cord