Filter
Top Products
Playback
75
Frame-by-frame playback (P2 card / Tape)
1 Press the button during playback to set
the unit to the pause mode.
2 Press the PAGE/AUDIO MON/VAR button to
play frame-by-frame.
On the remote control unit, press the STILL
ADV (
or ) button.
• Press and hold the button to perform frame-
by-frame play continuously.
PAGE/
AUDIO MON/VAR
INDEX STOP INDEX
STILL ADV
PAU S E
STILL ADV
PLAY
INDEX STOP
V
-
/REW FF/
Camera or Remote control
Press the
button to return to normal playback.
Clip skip (P2 card)
1 During playback, press the button to
pause the camera.
2 Press the (backward) or (forward)
button.
INDEX STOP INDEX
STILL ADV
PAU S E
STILL ADV
PLAY
INDEX STOP
V
-
/REW FF/
Camera or Remote control
End search (Tape)
You can find unrecorded parts or the end of the
last scene shot.
1 In the setup menus, OTHER FUNCTIONS
screen, END SEARCH, set the search
method. (Page 116)
BLANK: Find unrecorded parts.
REC END: Find the end of the last scene shot.
2 When in the VCR mode
Press the END SEARCH button.
• The unrecorded parts are found, and an
unrecorded blank on the tape is found, and a
still picture several seconds before the blank
is displayed.
When in the camera mode
Press and hold the END SEARCH button for
at least a second.
• A blank portion of the tape is found, and
an unrecorded blank on the tape is found,
and the pause status is established several
seconds before the blank.
END SEARCH
• If you change the tapes, the camera will not be
able to find the end of the last scene shot even if
you have set REC END.
• If the tape is blank, searching stops at the end of
the tape.
• This function may not work properly if there are
blank parts near the beginning of the tape or part
way through the tape.
• Before recording, check the still picture first.