Filter
Top Products
116
Setup menu list (continued)
Item
Display
mode
Description of settings
END SEARCH
TAPE
(Camera)
(VCR)
Sets the operation when the END SEARCH button is pressed.
BLANK: Searches for the unrecorded parts on the tape.
REC END: Searches for the last segment shot.
PC MODE
P2
(Camera)
(MCR)
Selects the terminal for data transfer. (You cannot select USB and 1394 at the
same time.)
USB DEVICE:
Mode for sending files using the USB connector.
1394 DEVICE:
Mode for sending files using the 1394 connector.
1394 HOST:
Mode for copying files from the P2 card onto an external hard disk drive using
the 1394 connector.
REC LAMP
P2
TAPE
(Camera) Sets lighting of the tally lamp.
OFF:
The tally lamp does not light.
FRONT:
Front tally lamp (microphone side) lights.
REAR:
Rear tally lamp (viewfinder side) lights.
BOTH:
Both tally lamps light.
ACCESS LED
P2
(Camera)
(MCR)
Sets the access lamp to ON or OFF.
ON:
The lamp lights up and blinks as per the regular specifications.
OFF:
The lamp is OFF in all circumstances.
BEEP SOUND
P2
TAPE
(Camera) Turns the beep sound ON or OFF.
ON OFF
When ON is selected, the beep is sounded under the circumstances set forth
below.
When the beep is sounded, the audio signals from the output connector are
muted before the beep sound is output.
• When the memory of the P2 card or the tape has been used up during
recording
• When a recordable tape has not been loaded when the power is turned on
• When a recording-inhibited tape has been inserted
• When condensation has formed inside the camera-recorder
• When trouble has occurred in the camera-recorder
<Note>
When LIVE has been set for the HP MODE option on the AV IN/OUT SETUP
screen, no beeping sounds will be emitted even if ON is set for the BEEP
SOUND option.
CLOCK SET
P2
TAPE
(Camera)
(MCR/
VCR)
Sets the camera-recorder’s calendar.
indicates the factory setting.
OTHER FUNCTIONS screen (continued)