Filter
Top Products
Editing
79
1
2
1394
Digital video equipment (Dubbing)
You can connect a digital video unit equipped with a DV connector and digitally transfer video
and audio signals as well as time code.
• Before proceeding to connect or disconnect 1394 cable, be absolutely sure to turn off the power of the
units.
• Before proceeding to connect the unit which uses a 6-pin type 1394 connector,
carefully check the shape of the 1394 cable and the connectors on the 1394
cable. Connecting a connector upside down may damage the parts inside the
unit and cause malfunctioning. Furthermore, connect the 1394 cable to the unit
which uses a 6-pin type 1394 connector first. (
→ )
• When recording signals from an external unit, first check that video signals are
supplied.
• While signals from an external unit are being recorded, do not stop output on
the external unit side or disconnect any of cables. This may lead to a failure to
recognize the signals when you do recording again.
• While signals from an external unit are being recorded, do not change the format of the signals being
output from the external unit. Doing so may make it impossible to record correctly.
• Do not apply force when connecting 1394 cable to 1394 connector as this may damage the connector.
• No guarantees are made for the playback images when signals from an external device are recorded.
(Video check level)
• The automatic recording function in the DVD unit may not function properly. In a case like this, proceed
with the recording manually.
This camera
1394 cable (optional)
4-pin type
Other Digital video equipment
6-pin
type
4-pin
type
• Before proceeding to connect or disconnect 1394 cable, be absolutely sure to turn off the power of the
units.
• Before proceeding to connect the unit which uses a 6-pin type 1394
connector, carefully check the shape of the 1394 cable and the connectors
on the 1394 cable. Connecting a connector upside down may damage the
parts inside the unit and cause malfunctioning. Furthermore, connect the
1394 cable to the unit which uses a 6-pin type 1394 connector first. (
→
). The above also applies to USB cable as well.
• Do not apply force when connecting 1394 cable to 1394 connector as this may
damage the connector.
• When connecting to a PC, attach the ferrite core (provided) to the 1394 cable
in such a way that the whole ferrite core fits within about 5 cm from the PC’s
connectors. After threading the cable as shown in the figure on the right, close
the ferrite core until it clicks into place and locks.
6-pin
type
4-pin
type
Ferrite core (provided)