Panasonic AG-HVX200AP Camera Accessories User Manual


 
Shooting
41
Using presets
Use this feature when you have no time to make
white balance adjustments.
1 If the camera is in auto mode, use the AUTO/
MANUAL switch to switch to manual mode
(
on the viewfinder and LCD goes out).
2 Set the WHITE BAL switch to PRST.
The current white balance value appears.
• White balance values 3200 K and 5600 K are
preset in the PRST position.
Guide to the preset values
P3.2K (3200 K): halogen light
P5.6K (5600 K): outdoors
3 Press the AWB button.
White balance switches between 3200 K and
5600 K.
Black balance adjustments
In order to reproduce the black accurately, adjust
the zero level of all three RGB primary colors. If the
black balance is not adjusted properly, not only will
the black be reproduced poorly but the color tones
of the entire screen will also be downgraded.
It is not normally necessary to adjust the black
balance. Adjust it when:
• You use the camera for the first time.
• You use the camera after not using it for a long
time.
• The ambient temperature changes greatly.
• You switch to the normal (OFF) shutter speed or
to slow shutter.
• You switch between the progressive and normal
(60i) modes.
Press the AWB button to automatically adjust the
white balance.
Press and hold the AWB button to adjust the black
balance.
• As the white balance is adjusted first when you
press the AWB button, make the necessary
preparations for this.
• You cannot adjust the black balance while you
are shooting.
Message during adjustment
ABB ACTIVE
Message after adjustment
ABB END
Auto Tracking White (ATW)
You can allocate the ATW feature to one of the
positions on the WHITE BAL switch (A, B, or
PRST). Allocate it by going to the setup menus,
SW MODE screen, ATW. (Page 104)
The ATW feature is set to work in the auto mode at
the time of shipping. (Page 106)
If you use the ATW feature whenever you are
shooting, the camera automatically adjusts the
white balance as you shoot.
• The ATW feature automatically determines the
current shooting environment and adjusts the
white balance accordingly. Depending on the
environment, there may be some error in the
adjustment.
Use the procedure described on the preceding
page whenever you need more precise white
balance.
Do not block the white balance sensor when using
the ATW feature. ATW will not work if you do.
White balance sensor
Adjusting the white balance (continued)