Filter
Top Products
Displays
95
WRITE PROTECTED
The P2 card or SD memory card is write-
protected.
NO CARD
A P2 card or SD memory card has not been
inserted.
NO FILE
There are no files (version upgrade files, etc.).
Errors
These are displayed when an error occurs in the
unit, P2 card, tape, or other component. If the
problem is not fixed by turning the power off and
then on again, either replace the card or tape
based on the error information, or consult with your
dealer as to which one is to be purchased.
AUTO OFF
When trouble occurs with tape running systems,
AUTO OFF is displayed.
When AUTO OFF is displayed, the power supply
of this device is automatically set to OFF.
CYLINDER LOCK
LOADING LOCK
UNLOADING LOCK
T REEL LOCK (Take up reel lock)
S REEL LOCK (Supply reel lock)
CANNOT PLAY
This is displayed when trouble has occurred
during playback.
CARD ERR (1) (2) (1/2)
(Trouble has occurred in the P2 card found in the
slot indicated by the number.)
CLIP ERROR (clip trouble)
UPDATING (clip recording)
ERROR (other type of trouble)
SYSTEM ERROR
This is displayed when trouble has occurred in
the system. Switch ON the power again.
P2 MICON ERROR (no P2 microcomputer
response)
P2 CONTROL ERROR (trouble in P2 control)
REC RAM OVERFLOW (recording RAM
overflow)
TURN POWER OFF
This display appears when an abnormality occurs
as a result of the card being pulled out while data
is being accessed.
REC WARNING
This is displayed when trouble has occurred
during recording. Carry out recording once again.
If the warning persists, consult your dealer.
CARD ERR (1) (2) (1/2)
(Trouble has occurred in the P2 card found in the
slot indicated by the number.)
• If the warning continues, turn off the power.
• If the warning appears even when recording is
carried out again, replace the card with another
one.
ERROR (other type of trouble)
WARNING
When trouble occurs with camera systems,
WARNING is displayed.
FOCUS LOCK (Abnormal focus operation)
PSD NG (Abnormal vibration detected)
GYRO NG (Abnormal Optical Image Stabilizer
control)
1394
This is displayed when trouble has occurred in
the 1394 connections or signals. (P2 mode only)
1394 INITIAL ERROR (connection error)
1394 INPUT ERROR (input error)
1394 INPUT ERROR (OTHER FORMAT) (wrong
input format)