Filter
Top Products
135
VQT3U98
∫ It is not a malfunction in following cases
Others
Troubleshooting
A clicking sound is heard
when the unit is shaken.
≥ This is the sound of the lens moving and is not a defect.
This sound will no longer be heard when the unit is turned
on and change the mode to .
Object seems to be
warped.
≥ Object seems to be warped slightly when the object moves
across the image very fast, but this is because the unit is
using MOS for the image sensor. This is not a malfunction.
Power
Problem Check points
This unit cannot be
turned on.
This unit does not stay
on long enough.
Battery runs down
quickly.
≥ Charge the battery again to ensure it is sufficiently
charged. (l 18)
≥ In cold places, the battery using time becomes shorter.
≥ The battery has a limited life. If the operating time is still
too short even after the battery is fully charged, the
battery has worn out and needs to be replaced.
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥ Remove the battery or AC adaptor, wait about 1 minute
and then reconnect the battery or AC adaptor. Then
about 1 minute later, turn on the unit again. (Conducting
the above operation while the media is being accessed
may damage the data on the media.)
≥ If normal operation is still not restored, detach the power
connected, and contact consumer support. (l 156)
“ERROR OCCURRED.
PLEASE TURN UNIT
OFF, THEN TURN ON
AGAIN.” is displayed.
≥ The unit has automatically detected an error. Restart the
unit by turning the unit off and on.
≥ The unit will be turned off in about 1 minute if the unit is
not turned off and on.
≥ Repair is needed if it is repeatedly displayed even if it is
restarted. Detach the power connected, contact
consumer support. (l 156) Do not attempt to repair the
unit by yourself.
HDC-Z10000P-VQT3U98_mst.book 135 ページ ２０１１年１０月４日 火曜日 午後３時２分