Filter
Top Products
40
VQT3U98
2 Rotate the CONV. dial to adjust the
convergence point.
≥ This can be set between C00 and C99. Position of the
convergence point will be set further when the number
is larger.
≥ The subject at the position of the convergence point will
not shoot out or recess from the screen. (It is seen as
same as the 2D image)
≥ Adjust by checking on the 3D image or 3D guide display
on the LCD monitor. (l 41)
≥ When zooming, it may be necessary to readjust the convergence point.
About Convergence Reset
When a convergence reset is performed, the display of the convergence point goes to ,
and the convergence point is automatically set to prevent 3D video that tires or discomforts
the viewer. When the zoom magnification is changed, the convergence point is adjusted
automatically, so please use this setting you wish to record faraway subjects without worrying
about convergence. (l 73)
≥ Optimal distance range for subject at Convergence Reset.
* This is the target when the [3D GUIDE] is set to [MODE1]. (l 41)
To adjust the convergence point with MIX display
Images from the left and right lenses are displayed overlapping when the 3D display is set to
MIX display. Adjust the convergence point so the outlines of the subject to be the reference
plane are overlapping exactly.
≥ The left and right images will not be perfectly aligned if the subject is located at a distance
of less than approximately 45 cm (17.7 q).
≥ Please refer to page 72 for information on the 3D display.
≥ 3D image can be recorded as close as approximately 45 cm from the lens when the zoom
magnification is set to 1k.
Zoom magnification
Optimal distance range between this unit and the
subject
*
1
k
(Z00)
approximately 0.9 m (3 feet) or further
4k
(Z70)
approximately 3.4 m (11.2 feet) or further
8k
(Z92)
approximately 6.7 m (22 feet) or further
10
k
(Z99)
approximately 8.3 m (27.2 feet) or further
CONV.
HDC-Z10000P-VQT3U98_mst.book 40 ページ ２０１１年１０月４日 火曜日 午後３時２分