Filter
Top Products
60
VQT3U98
To remove the external microphone, etc., from the audio input terminals 1, 2
(XLR 3 pin)
Remove while pushing on the PUSH section of the audio
input terminals 1, 2 (XLR 3 pin).
≥ Set the input signal to built-in microphone by switching
the CH1, CH2 switches to INT (L) or INT (R) after
removing the external microphone. Audio will not be
recorded when motion picture is recorded without
switching.
≥ Set INPUT1,2 (+48V) switches to OFF if you connect equipment not compatible with
+48 V. You can damage this unit or such equipment if you leave the setting at ON.
≥ This unit is turned off when a problem occurs with the +48 V power supply.
≥ The battery will discharge faster if you use a phantom microphone.
≥ When inputting the external microphone signal to audio channels 1 and 2, connect the
external microphone to audio input2 terminal (XLR 3 pin) and switch both CH1 and CH2
switches to INPUT2.
ヱヶヴラ
A PUSH section
HDC-Z10000P-VQT3U98_mst.book 60 ページ ２０１１年１０月４日 火曜日 午後３時２分