Filter
Top Products
Operating Instructions
[For assistance : 1-800-272-7033] 11
1.3 Part Names
1.3.1 Front View
Information
Power LED blinks in the following states.
• While lens moves to the Home Position after turning on the power.
• When performing Update Firmware.
• When you pushed CLEAR SETTING button.
• The KX-HCM10 hardware is defective. Please refer to Section
4.2 Troubleshooting.
CAUTION
• Network Camera is intended for indoor use only. Prolonged exposure to direct
sunlight or halogen light may damage the CMOS sensor.
• If you display the same image on the PC monitor for a long time, damage of
the monitor such as sticking may occur. You should use screen saver.
• Do not force the movement of the camera while panning or tilting the view. This
can damage the internal drive motors.
• Do not touch the lens. It may leave a finger print and can cause the image to
be out of focus. This can also damage the protective coating on the lens.
Power LED
Fixed Focus Lens
(1m - Infinity)