Filter
Top Products
Operating Instructions
[For assistance : 1-800-272-7033] 21
turning on the power of the Network Camera.
4. During this process the Ethernet LED adjacent to the network
connector should be flashing.
6.
Select your target Network Camera in Box (i) and click the button.
The following Configuration screen is displayed.
See the Page 23 for instructions about each data fields.
Confirm the Connection No. of Section 1.4.1 Diagram of Connections,
and please setup the (ii) - (vi) of following items.
When you use Connection 1 in Section 1.4.1
(ii): Set to 80. [Default]
(iii): Check the Static and set Static IP Address and Subnet Mask.
(iv), (v), (vi): You don't need to set these items.
Select
(ii)
(iii)
(iv)
(v)
(vi)
(vii)