Filter
Top Products
Operating Instructions
84
Power LED continues
blinking after turn on
the Network Camera.
Please check whether you can access the camera with your
browser.
• If you can access the camera and the screen is Update
Firmware page, you should do Update Firmware
procedure.
• If you can not access the camera, the KX-HCM10
hardware is defective. Please call our customer call
center.
Renewal of an image is
slow.
• The number of the renewal frames of an image of a
camera changes from the following contents.
• Setting :
View mode/Image Resolution/Image Quality/
Network Bandwidth usage
• Use environment :
the personal computer performance currently used,
Network environment, subject conditions
(Brightness, subject, etc.)
• Renewal of an image becomes slow by two or more
users' simultaneous access.
For this reason, the performance indicated to Specification
may not come out according to the above conditions.
• On Multi-Camera, when renewal of an image is slow,
please use Ethernet Switching Hub. (If Ethernet
Switching Hub is not used, the renewal of an image of
each screen may become slow.)
Problem Cause and Remedy