Filter
Top Products
Operating Instructions
64
When you click the button, Digital output terminal becomes low
(0V).
3.
When you have finished , click .
The setting will be saved.
LED Control
LED Control screen allows you to set the LED Control parameters.
• It is possible to set LED ON or OFF.
1.
Click the LED Control button on the Setup Page of Network Camera.
The next screen appears.
2.
Select the LED Control parameter.
• To reset the current settings, click .
Then it returns to Setup Page, without saving setting value.
3.
When you have finished , click .
• The setting will be saved.
Restart
Restart screen allows you to set restart.
• It is possible to restart the Network Camera. Restart is as same as returning
on power supply.
1.
Click the button on the Network Camera Setup Page.
The next screen appears.
Information
• It is shown in Section 3.1 I/O Connector.
Short to GND
Save
Cancel
Save
Restart