Filter
Top Products
257
Appendix
12
The USB
connection
with a printer
does not
work
properly
The USB
Connection is set to
[PC]
Set [USB Connection] in the [R Set-up 2]
menu to [PictBridge]. (p.204)
Shake
Reduction
does not
work
The Shake
Reduction function
is off
Turn on the Shake Reduction function.
(p.122)
The Shake
Reduction function
is not set properly
If a lens for which focal length information
cannot be acquired is used, set the [Focal
Length] on the [Input Focal Length] menu.
(p.124)
Shutter speed is too
low for the Shake
Reduction function
to be effective when
panning or shooting
night scenes, etc.
Turn off the Shake Reduction function and
use a tripod.
The subject is too
close
Move away from the subject, or turn off the
Shake Reduction function and use a tripod.
In rare cases, the camera may not operate correctly due to static electricity.
This can be remedied by taking the batteries out and putting them back in
again. When the mirror remains in the up position, take the batteries out and
put them back in again. Then, turn the power on. The mirror will retract. After
the procedure is done, if the camera operates correctly, it does not require any
repairs.
Problem Cause Remedy