Filter
Top Products
USING THE MENU SCREEN SYNC/VBS
C External sync setting (VBS)
1 Connect the output signal from the other camera to the external sync input
connector of this camera.
The SYNC setting in the MAIN MENU screen will change to VBS.
2 Press the CURSOR (l) button to select the SYNC setting “VBS” (the setting will
flash), then press the SET button.
The ADJUSTMENT FOR VBS screen will be displayed.
3 The H (horizontal) value will flash. Press the CURSOR (d or c) button to adjust the
horizontal sync phase.
Note: If not using a camera (for the output signal), use a sync signal generator.
4 Press the CURSOR (l) button until the SC1 (sub-carrier) value is flashing, then press
the SET button to select the color phase (SC1 to SC4).
5 Press the CURSOR (d or c) button to make fine adjustments to the color phase.
☞ Returning the value to the default setting
Press the CURSOR (l, then d or c) button to change the PRESET setting to ON, then
press the SET button.
MAIN MENU
LANGUAGE SET p
CAMERA ID OFF
SYNC VBS p
ADJUSTMENT FOR VBS
[PHASE]
H íú-----z------ü 32
SET
CURSOR
SC1
ú------z------ü 1
SC1 ➞ SC2 ➞ SC3 ➞ SC4
L53R4/US GB 1999, 12, 7
20 English