Filter
Top Products
USING THE MENU SCREEN MOTION/SENSITIVITY
D SENSITIVITY setting
The smaller the setting value, the greater the sensitivity.
Press the CURSOR (l) button to select the SENSITIVITY setting “SET” (the setting will flash),
then press the SET button.
The SENSITIVITY screen will be displayed.
MOVE
This sets the movement amplitude of subjects on the screen.
Press the CURSOR (d or c) button so that the MOVE value is flashing. (Maximum: 6)
Set the value to a large to avoid detecting slight movement such as movement caused by the wind.
Y-LEVEL
This sets the brightness level. Any signal darker that the set brightness will be ignored.
This is mainly used to avoid incorrect detection caused by electronic noise in a dark
picture.
Press the CURSOR (l, then d or c) button so that the Y-LEVEL value is flashing. (Maximum: 10)
Set the value to a large to avoid incorrect detection of movement caused by electronic noise
from a dark picture.
Y-DIFFER
This sets the brightness change level. A lower setting will ignore bigger changes in the
brightness.
Press the CURSOR (l, then d or c) button so that the Y-DIFFER value is flashing.
(Maximum: 10)
This allows movement to be detected when there are variations in brightness. Set the value to a
large if lights being turned on and off are not to be detected.
ADJUSTMENT FOR MOTION
DIRECTION OFF
SIZE SET p
MASKING ON p
SENSITIVITY SET p
CURSOR
SET
CURSOR
SET
SENSITIVITY
MOVE í---ú----ü 3
Y-LEVEL í-ú------ü 3
Y-DIFFER í------ú-ü 8
DURATION ú--------ü 1
L53R4/US GB 1999, 12, 7
English 43