Filter
Top Products
4
Chapter 4 Adjustments and Settings for Recording4-30
• PAINT menu
This menu contains items for making detailed image adjustments while
using a waveform monitor to monitor the waveforms output by the
camera. Usually, the support of a video engineer is required to use this
menu. Although you can also use an external remote control panel or
master setup unit to set the items on this menu, this menu is effective
when using the camcorder by itself outdoors. This menu allows you to
perform almost the same settings as those of the PAINT menu of the
MSU-700A/750 Master Setup Unit (not supplied).
• MAINTENANCE menu
This menu contains items for performing camera maintenance operations
such as changing the system or infrequently used paint items. This menu
allows you to perform almost the same settings as those of the
MAINTENANCE menu of the MSU-700A/750 Master Setup Unit (not
supplied).
• FILE menu
This menu is used for performing file operations such as writing the
reference file.
• DIAGNOSIS menu
This menu enables you to confirm the VTR status or a failed circuit
board.
To return to the TOP menu
The following two methods are available:
• Point the arrow (→) to TOP on the right top on each page, then press
the MIC/MENU knob.
• Push the MENU switch to the CANCEL side twice.