Filter
Top Products
2
Chapter 2 Locations and Functions of Parts and Controls2-32
4 HOLD (display hold) button
Pressing this button instantly freezes the time data displayed in the
counter display section. (The time code generator continues normal
operation.) Pressing this button again releases the hold. One use of this
feature is to determine the exact time of a particular shot.
When the HOLD button is activated, the time data is dsiplayed in the
following format:
See Section 2-8 “Warnings and Indications on the Display Panel” (page 2-38) for
more information about the counter display.
5 RESET (counter reset) button
This button resets the time data displayed on the counter display section
to “00:00:00:00” and the user bit data to “00000000".
6 DISPLAY (LCD) switch
Depending on the settings of the F-RUN/SET/R-RUN switch and the
REAL TIME switch, this switch selects data to display in the counter
display section as follows:
CTL: Control signal
U-BIT: User bits
TC: Time code
For more information, see “Time code displays” (page 2-40).
7 ADVANCE button
For setting the time code, user bits, or real time, each press of this button
increments the flashing digit selected by the SHIFT button.