Filter
Top Products
2
Chapter 2 Locations and Functions of Parts and Controls 2-7
4 LEVEL (CH-1/CH-2) (audio channel 1 and channel 2 recording
level) controls
These controls adjust the audio levels of channels 1 and 2 when audio
input is from the AUDIO IN CH-1/CH-2 connectors and the AUDIO
SELECT switches are set to MANUAL.
5 AUDIO SELECT (CH-1/CH-2) (audio channel-1 and channel-2
adjustment method select) switches
These switches select the audio level adjustment method for each of
audio channels 1 and 2.
AUTO: Select this setting for automatic adjustment.
MANUAL: Select this setting for manual adjustment.
6 AUDIO IN (CH-1/CH-2) (audio input) switches
These switches select the audio input signals to be recorded for audio
channels 1 and 2.
FRONT: The input signal source is the microphone connected to the
MIC IN connector.
REAR: The input signal source is the audio equipment connected to the
AUDIO IN CH-1/CH2 connectors.
You can also record audio signals in audio channels 3 and 4.
You can select the input signals to be recorded for audio channels 3 and
4 by using the AU REC CH 3/4 item on the VTR SETUP page of the
MAINTENANCE menu.
The following three input signals are available:
1/2 CH: Records the same input signals connected to the AUDIO CH-1/
CH-2 connectors in audio channels 3 and 4..
AUTO: Records inputs signals other than the signals connected to the
AUDIO CH-1/CH-2 connectors, that is signals which are not selected
using the AUDIO IN switches.
This is effective only when the HDCA-901 camera adaptor is turned off,
if connected.
For example: When the CH-1 of the AUDIO IN switch is set to FRONT:
The audio signal input to the AUDIO IN CH-1 connector is recorded in
channel 3.