Filter
Top Products
29CV501 - 16CH
The event log setup allows you to choose which alarm triggers will be saved to your event log (maximum 3000 events). Setting up the event log
allows you to start playing recorded footage by specic events so that you do not have to fast forward through long periods of footage to see
when the alarm is detected. It also serves as a list with the important events that have occurred, so that you can easily trace them, and when they
happened.
To Setup the Event Log:
1. Highlight EVENT LOG SETUP.
2. Select to access the Event Log Setup Menu.
3. Highlight the type of alarm you want to enable or disable.
4. Use the mouse wheel or directional keys to change from ON to OFF.
5. Press Menu or select the
to return to the Menu and save your settings.
6. Press Menu or select the
to exit the Main Menu. The DVR may take a few moments to load the settings.
BUZZER TIME SETUP
The DVR can make an audible beep when a particular alarm is detected. This will alert the user that there is activity detected by the DVR. The DVR
can be set to give you this audio alert when there is external alarm activation, motion detection, and/or video loss. Buzzer Time setup will allow
you to choose how long after the alarm is detected, you want the beep to occur. The options are OFF and 5 sec – 99 sec. The buzzer for Motion
Detection can be set from 5 sec -99sec. To disable the motion detection buzzer, refer to the MOTION SETUP Menu).
MAIN MENU...continued
To Change the Buzzer Time:
1. Highlight BUZZER TIME SETUP.
2. Select to access the Buzzer Time Setup Menu.
3. Highlight the type of alarm you want to set.
4. Use the mouse wheel or directional keys to change the length of time the buzzer will sound when the alarm is detected.
5. Press Menu or select the
to return to the Main Menu, or press the ENTER key.
6. Press Menu or select the
to exit the Main Menu and save your settings. The DVR may take a few moments to load the settings.
RELAY TIME SETUP
The DVR has a connection for an alarm relay output. This allows you to connect a 2 wire Normally Open (NO), or Normally Closed (NC) connection to
an external alarm source like a siren, ashing lights, or an existing two wire security system.
Relay time setup allows you to adjust the length of time the DVR will send an electrical signal through the connected relay device. An external
power source is likely required. Please contact your alarm manufacturer for information and assistance with your alarm.
Note: SVAT does not provide support for external alarm systems. Please contact the alarm manufacturer for instructions.