SVAT Electronics cv501-16ch Security Camera User Manual


 
53CV501 - 16CH
TESTING
Now that you know your external IP address, you can perform a test to ensure your DVR is accessible from outside your network (over the internet).
This test should be performed by a computer that is not on the same network as the DVR. Although, using the external IP on the same network will
sometimes work, it will not work in all cases and it is best to test from a remote location.
1. Open Internet Explorer, and in the address bar type in the external IP address you acquired from http://whatsmyip.org. It should be similar
to the following: http://74.11.213.177. If using a port other then the default port 80 it will need to be entered at the end of the IP address. Ex.
http://74.11.213.177:2000.
2. Press ENTER.
ONCE SUCCESSFUL
You will be prompted to enter your username/password and install the ActiveX controls
You are now able to view the DVR from anywhere in the world with Internet access and proper computer settings
IF YOU CANNOT CONNECT
If the Remote Viewing does NOT connect it could be caused by one of the following reasons:
Make sure the browser is Internet Explorer 6.0 or later and is on a Windows PC
Check all your network connections and go through the above steps again to make sure a conguration error was not made. You may have to
congure PPPoE settings to match the settings provided to you by your Internet Service Provider (ISP). Consult your ISP for more information
on your PPPoE settings
Port forwarding is not set up correctly. Review the section “CONFIGURING YOUR ROUTER (PORT FORWARDING)” and www.portforward.
com for setup instructions
A pop-up blocker is preventing the ActiveX controls from prompting you to install
Your router is blocking your computer from using the external IP address from the same network as the DVR. Try connecting to the External IP
Address from a remote computer that is not connected to the same network
Port 80 is being blocked by your ISP (Internet Service Provider). Try changing the HTTP port to 2000. Port forwarding will need to be setup for
the new port
A DSL modem is preventing the connection because it is on a dierent sub-network. Contact your ISP to assist with bridging the modem and
router together
Note: SVAT technical support cannot troubleshoot modems, since changing these settings can potentially render your modem
inoperable. Bridging or any other modications to the modem will need to be completed by the ISP.
NETWORK GUIDE...continued