Filter
Top Products
Dinion IP Configuration via the browser | en 51
Bosch Security Systems Operating Instructions V 2.5 | 2007.6
Profile name
You can enter a new name for the profile here. The name is then
displayed in the list of available profiles in the Active encoder
profile: field.
Target data rate
To optimize utilization of the bandwidth in your network, you
can limit the data rate for the camera. The target data rate
should be set according to the desired picture quality for typi-
cal scenes with no excessive motion.
For complex images or frequent changes of image content due
to frequent movements, this limit can temporarily be exceeded
as far as the value you enter in the Max. data rate: field.
Encoding interval
The figure selected here determines the interval at which
images are encoded and transmitted. For example, entering 4
means that only every fourth image is encoded, the following
three images are skipped – this can be particularly advanta-
geous with low bandwidths. The image rate in IPS (Images Per
Second) is displayed next to the text block.
Video resolution
Here, you can select the desired resolution for the MPEG-4
video image. The following resolutions are available:
– QCIF 176 × 144/120 pixels
– CIF 352 × 288/240 pixels
– 1/2 D1 352 × 576/480 pixels
– 2CIF 704 × 288/240 pixels
– 4CIF/D1 704 × 576/480 pixels
– 2/3 D1 464 × 576/480 pixels
i
NOTE! The parameters as a group constitute a profile and are
dependent on one another. If you enter a setting outside the
allowed range for a parameter, the nearest valid value is
substituted when the settings are saved.