Filter
Top Products
Dinion IP Configuration via the browser | en 87
Bosch Security Systems Operating Instructions V 2.5 | 2007.6
nents and can send SNMP messages (traps) to IP addresses. It
supports SNMP MIB II in the unified code. If you wish to send
SNMP traps, enter the IP addresses of one or two required tar-
get devices here.
To choose which traps are sent:
1. Click Select. A dialog box appears.
2. Click the check boxes of the appropriate traps.
3. Click OK to close the window and send all of the checked
traps.
Authentication
If a Radius server controls access rights in the network, you
must activate authentication to communicate with the device.
1. Enter the user name that the Radius server uses for the
camera in the identity field.
2. Enter the password that the Radius server expects from
the camera.
The Radius server must also be appropriately configured.
Automatic IP assignment
If the network has a DHCP server for dynamic IP allocation, you
can activate DHCP here. In this case, the IP entered above on
this page is overwritten the next time the camera restarts.
7.15.2 Multicasting
In addition to a 1:1 connection between an encoder and a sin-
gle receiver (unicast), the camera can enable multiple receivers
i
NOTE! The DHCP server must be configured to allocate static IP
addresses based on MAC addresses so that the camera always
receives the same address. If not, controlling systems, such as
VIDOS or BVMS, will not find the camera.