Filter
Top Products
Dinion IP Connections between video servers | en 97
Bosch Security Systems Operating Instructions V 2.5 | 2007.6
8 Connections between video servers
A camera can be used as a transmitter and a compatible MPEG4
hardware decoder with a connected monitor as a receiver using
an Ethernet network connection. This way it is possible to cover
large distances with little effort for installation or cabling.
8.0.1 Installation
Cameras are designed to connect with other VIP devices auto-
matically with the corresponding configuration. This only
requires that they are part of a closed network. Proceed as fol-
lows to install the devices:
1. Connect the devices to the closed network using Ethernet
cables.
2. Connect them to the power supply.
8.0.2 Establishing the connection
There are three options for establishing a connection between a
transmitter and a compatible receiver in a closed network:
– an alarm,
– a Web browser
– via the configuration manager
8.0.3 Connect on alarm
With the appropriate configuration, a connection between a
transmitter and a receiver is established automatically when an
alarm is triggered. After a short time, the live video image from
the transmitter is shown on the connected monitor.
This connection option can also be used to connect a transmit-
ter and a compatible receiver using a switch connected to the
alarm input. In this case, no computer is needed to establish
the connection.
i
NOTE! Make sure the devices are configured for the network
environment and the correct IP address for the remote location
to be contacted in the event of an alarm is set on the Alarm
connections configuration page.