Filter
Top Products
74 en | Configuration via the browser Dinion IP
V 2.5 | 2007.6 Operating Instructions Bosch Security Systems
7.11.2 Alarm connections
You can select the response of the camera when an alarm
occurs. In case of an alarm, the camera can automatically estab-
lish a connection to a predefined IP address (compatible
MPEG-4 compatible hardware receiver or computer with recep-
tion software). You can enter up to ten IP addresses which will
be selected in order by the unit in case of an alarm until a con-
nection is established.
Connect on alarm
Select On so that the camera automatically establishes a con-
nection to a pre-defined IP address in the event of an alarm.
Number of destination IP address
Here you assign the numbering for the IP addresses to be con-
tacted in the event of an alarm. The unit contacts the remote
locations one after the other in the numbered sequence until a
connection has been established.
Destination IP address
For each number, enter the corresponding IP address for the
desired remote location.
Destination password
If the remote location is password protected, enter the pass-
word here.
Only ten passwords can be defined here. You can define a gen-
eral password if more than ten connections are required, for
i
NOTE!
Stream 2 is always transmitted for alarm connections. This
should be taken into account when assigning the profile.