Filter
Top Products
84 en | Configuration via the browser Dinion IP
V 2.5 | 2007.6 Operating Instructions Bosch Security Systems
7.15 Service Settings
7.15.1 Network
The settings on this page are used to integrate the unit into an
existing network.
– Click Set after entering a new IP address.
– To do this, enter the old IP address followed by /
reset (for instance 192.168.0.80/reset) in the
address bar of your web browser. When the camera is
i
NOTE!
Changes to the IP address, subnet mask or gateway address are
transferred to the unit by clicking Set. However, they do not
become active until the device is restarted.