Filter
Top Products
96 en | Configuration via the browser Dinion IP
V 2.5 | 2007.6 Operating Instructions Bosch Security Systems
Configuration upload
1. Enter the full path of the file to upload or click Browse... to
select the desired file.
2. Make certain that the file to be loaded comes from the
same device type as the unit you want to reconfigure.
3. Click Upload to begin transmission to the unit. The
progress bar allows you to monitor the transfer.
Once the upload is complete, the new configuration is acti-
vated. The time remaining is shown by the message going to
reset Reconnecting in ... seconds. After the upload is com-
pleted successfully, the unit restarts automatically.
SSL certificate upload
To work with an SSL connection, both sides of the connection
must have the appropriate certificates. You can upload one or
more certificate files, one at a time, to the camera.
1. Enter the full path of the file you wish to upload or click
Browse... to locate the file.
2. Click Upload to start the file transfer.
The unit restarts automatically after a successful upload.
7.16 Function test
The camera offers a variety of configuration options. Therefore
you should check that it works properly after installation and
configuration. This is the only way to ensure that the camera
will function as intended in the event of an alarm.
Your check should include the following functions:
– Can the camera be called remotely?
– Does the camera transmit all the data required?
– Does the camera respond as desired to alarm events?
– Is it possible to control peripheral devices if necessary?