Filter
Top Products
102
3 Customizing AF FunctionsN
During manual AF point selection, the selection can either stop at the
outer edge or it can move to the opposite AF point. This function works
in AF area selection modes other than 61-point automatic selection AF
and Zone AF. (It works in 61-point automatic selection AF only with AI
Servo AF.)
: Stops at AF area edges
Convenient if you often use an AF point
along the edge.
: Continuous
Instead of stopping at the outer edge, the
selected AF point continues to the
opposite side.
You can set whether or not to display the AF point(s) in the following
cases: 1. When selecting the AF point(s), 2. When the camera is ready
to shoot (before AF operation), 3. During AF operation, and 4. When
focus is achieved.
: Selected (constant)
The selected AF point(s) is always
displayed.
: All (constant)
All 61 AF points are always displayed.
: Selected (pre-AF, focused)
The selected AF point(s) is displayed for 1, 2, and 4.
: Selected (focused)
The selected AF point(s) is displayed for 1 and 4.
OFF: Disable display
For 2, 3, and 4, the selected AF point(s) will not be displayed.
25
Manual AF point selection pattern
AF point display during focus