Filter
Top Products
292
3 Appending Dust Delete DataN
3
Photograph a solid-white object.
At a distance of 20 cm - 30 cm (0.7 ft.
- 1.0 ft.), fill the viewfinder with a
patternless, solid-white object and
take a picture.
X
The picture will be taken in aperture-
priority AE mode at an aperture of f/22.
Since the image will not be saved, the
data can still be obtained even if there
is no card in the camera.
X
When the picture is taken, the camera will
start collecting the Dust Delete Data.
When the Dust Delete Data is obtained, a
message will appear. Select [
OK
], and
the menu will reappear.
If the data was not obtained
successfully, a message to that effect
will appear. Follow the “Preparation”
procedure on the preceding page, then
select [
OK
]. Take the picture again.
After the Dust Delete Data is obtained, it is appended to all the JPEG
and RAW images captured thereafter. Before an important shoot, you
should update the Dust Delete Data by obtaining it again.
For details about using Digital Photo Professional (provided software,
p.390) to erase dust spots, refer to the PDF Software Instruction Manual
(p.393) on the CD-ROM.
The Dust Delete Data appended to the image is so small that it hardly
affects the image file size.
About the Dust Delete Data
Be sure to use a solid-white object such as a new sheet of white paper. If the
paper has any pattern or design, it may be recognized as dust data and
affect the accuracy of the dust deletion with the software.