Filter
Top Products
170
By changing the shutter speed or aperture automatically, the camera
brackets the exposure up to ±3 stops in 1/3-stop increments for three
successive shots. This is called AEB.
* AEB stands for Auto Exposure Bracketing.
1
Select [Expo.comp./AEB].
Under the [z2] tab, select [Expo.
comp./AEB], then press <0>.
2
Set the AEB range.
Turn the <6> dial to set the AEB
range. If you turn <5>, you can set
the exposure compensation.
Press <0> to set it.
X
When you exit the menu, <
h
> and the AEB
range will be displayed on the LCD panel.
3
Take the picture.
The three bracketed shots will be taken
according to the drive mode set in this
sequence: Standard exposure, decreased
exposure, and increased exposure.
AEB will not be automatically
canceled. To cancel AEB, follow step
2 to turn off the AEB range display.
h Auto Exposure Bracketing (AEB)N
AEB range
During AEB shooting, <A> and <h> will blink respectively in the
viewfinder and on the LCD panel.
If the drive mode is set to <
u
> or <
B
>, press the shutter button three times for
each shot. When <
o
>, <
i
>, or <
M
> is set and you hold down the shutter
button completely, the three bracketed shots will be taken continuously and the
camera will automatically stop shooting. When <
Q
> or <
k
> is set, the three
bracketed shots will be taken continuously after a 10-sec. or 2-sec. delay.
You can set AEB in combination with exposure compensation.
If the AEB range exceeds ±3 stops, the end of the exposure level indicator will display <
I
> or <
J
>.
AEB cannot be set for bulb exposures or used with flash.
AEB will be canceled automatically when you set the power switch to
<2> or when the flash is ready to fire.