Filter
Top Products
2-15
Cisco Video Surveillance Manager Getting Started Guide, Release 4.2/6.2
OL-19733-01
Chapter 2 Setting Up and Configuring the Multi Services Platform
Performing the Initial Configuration of the Multi Services Platform
Figure 2-6 YaST Control Center Window
Note The YaST Control Center times out after 5 minutes of inactivity. If a timeout
occurs, enter the password secur4u to redisplay the Control Center.
Configuring Network Settings
This section explains how to configure the settings that the Multi Services
Platform requires to operate on your network. To configure these settings, follow
these steps:
Procedure
Step 1 Access the YaST Control Center window as described in the “Powering On the
System and Accessing the YaST Control Center” section on page 2-12.
Step 2 In the left panel of the YaST Control Center window, click Network Devices, then
click Network Card in the right panel, as shown in
Figure 2-7.