Filter
Top Products
Chapter 3 Configuring VSM
Configuring VSM
3-12
Cisco Video Surveillance Manager Getting Started Guide, Release 4.2/6.2
OL-19733-01
Video encoders are required only if your deployment includes analog cameras. If
you will not use video encoders, skip this section.
Procedure
Step 1 Access the VSOM Operations Manager as described in the “Accessing Video
Surveillance Operations Manager” section on page 3-5
Step 2 In the VSOM Operator page, click the Admin link, which appears near the top left
of the page (see
Figure 3-14).
Figure 3-14 Admin Link
The Administration area appears.
Step 3 Click Encoders under Devices in the left panel of the VSOM Operator page, as
shown in
Figure 3-15.