Filter
Top Products
Chapter 6 Daily Care
Appendix
Glossary
Introduction
Index
Contents
TOP
112
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Daily Care
Operational
Settings
Cleaning the ADF (with cloth)
The ADF can be cleaned with a piece of cloth moistened with
Cleaner F1, or a sheet of Cleaning Wipe.
As the scanner continues to feed the documents, paper dust
will accumulate inside the ADF and it may cause scanning
errors.
Cleaning should be performed approximately every 5,000
sheets scanned. Note that this guideline varies depending on
the types of documents you scan. For instance, it may be
necessary to clean the scanner more frequently when you
scan documents on which the toner is not sufficiently fused.
1 Turn off the scanner and wait for at least 15 minutes.
For details, refer to "1.3 Turning the Power ON/OFF" (page 23).
2 Open the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page 24).
3 Clean the following locations with a cloth moistened with
Cleaner F1 or a sheet of Cleaning Wipe.
The glasses inside the ADF become very hot
when the scanner is being used.
Before you start cleaning the inside, make sure
to turn off the power, unplug the power cable and
wait at least 15 minutes for the ADF glass to cool
down.
z Do not use water or mild detergent to clean the ADF.
z It may take a long time to dry if an excessive amount of
Cleaner F1 is used. Use it in small quantity. Wipe off the
cleaner completely to leave no residue on the cleaned
parts.
Be careful not to have your fingers caught
when the ADF closes.
Make sure that the cloth does not get caught and damage
the document sensors.
Glass (×2)
Pick roller (×2)
Ultrasonic sensor (×2)
Idler roller (×4)
Feed roller (×2)
Eject roller (×2)
Brake roller (×2)
Document
sensor