Filter
Top Products
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
164
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Document check area
specification for
Multifeed Detection
(page 182)
Selected range: Select this item to restrict the area
to run multifeed detection.
[Selected range] check box Not selected
Enable / Disable (Middle): Specify whether to enable
or disable multifeed detection in the selected area.
Enable / Disable
(When [Selected range] is selected)
Disable
Start (Middle): Specify the start position of the area
in length (mm) from the leading edge of the
document.
0 to 510 mm (in increments of 2) 0 mm
End (Middle): Specify the end position of the area in
length (mm) from the leading edge of the document.
0 to 510 mm (in increments of 2) 0 mm
Intelligent Multifeed
Function
(page 185)
When there is a paper of the same size attached to
a designated location on the page, configure the
scanner to memorize the location of the attachment
and not detect multifeeds for that location.
Note that you first need to select [Check
Overlapping (Ultrasonic)] or [Check Overlapping
and length] in either the scanner driver’s setup
dialog box or the multifeed detection setting in
"Specifying a Multifeed Detection Method
[Multifeed]" (page 180).
Manual mode / Auto mode 1 / Auto mode 2 Manual mode
Select to clear the overlap pattern (length, location)
memorized in Auto mode.
[Clear overlap pattern] check box Not selected
Specify whether or not to memorize the multifeed
pattern upon power-off.
Remember / Do not remember Do not remember
Number of paper
feeding retries
(page 175)
Configure this setting to change the number of
feeding retries when a pick error occurs.
1 to 12 times 7 times
Life Counter Alarm
Setting
(page 168)
Specify the replacement cycle for the consumables. Pick Rollers / Brake Rollers:
10,000 to 2,550,000 sheets
(in increments of 10,000)
Pick Rollers:
200,000 sheets
Brake Rollers:
200,000 sheets
Item Description Parameter/Value Factory Default