Filter
Top Products
4-24 M3099EX/EH OEM Manual
In following case, the display of counter is deleted.
• The next Start Command is issued.
• The valid switches are pressed.
• The error is cleared.
The abrasioin counter is displayed after pressing [STOP] SW in the
initial screen.
In following case, the display of counter is deleted.
• The next Start Command is issued.
• The valid switches are pressed.
• The error is cleared.
Abrasion counter is not displayed if [STOP] SW is pressed in
blinking. This counter can be reset to zero by the procedure shown
in section B.3.6.
<IPC II pre-set mode>
When IPC II pre-set mode is set, an asterisk (*) is displayed. The
method of IPC II pre-set mode is shown in setup mode.
Screen of the simplex reading mode
Screen of the duplex reading mode
0
1234567891011121314
15
16 17 18 19 20 21
22 23
SF
A4 400 L >.
ⅥⅪⅪ
Abrasion counter
XXXXXX
0
1234567891011121314
15
16 17 18 19 20 21
22 23
SF
A4 400 L >.
ⅥⅪⅪ
*
0
1234567891011121314
15
16 17 18 19 20 21
22 23
SF
DF
A4 400 L >.
L>.
ⅥⅪⅪ
ⅥⅪⅪ
*