Filter
Top Products
M3099EX/EH OEM ManualB-4
Mode Details
ON/OFF “OFF” is default setting.
1 “1” is default setting.
This mode is used when the batch of paper which length are same
are scanned.
When the paper which tears and wrincled are scanned, Scanner
may mistake it also.
2 This mode is used when the batch of paper which length and
thickness are same are scanned.
However, when the thin papers are scanned, Scanner may mistake
to detect the Double-feed rarely.
In case of this, please test to scan the thin papers in advance.
<< SETUP MODE >>
IPC-2 SET
IPC-2 SET
No
IPC-2 SET
X
B3.2 Setting IPC-2 pre-set mode
When you set the using of IPC-2 pre-set mode, you must set as follows.
10 At Screen 2, press [Mode 1] twice to go to
the IPC-2 SET screen. (Screen 7)
11 Press [Mode 2] to see Screen 8 or 9. If “No”
is displayed, IPC-2 pre-set mode is not used.
If pattern number (“1”-”5") is displayed,
IPC-2 pre-set mode is used. “No” or number
status flips each time you press [Mode 1].
(The default setting is “No”.)
12 If you press the [Mode 2] at Screen 8, you
return to Screen 7. The setting is stored to
EEPROM. If you press the [Mode 2] at
Screen 9, you go to Screen 10.
13 If you press the [Mode 1] at Screen 10, IPC-
2 pre-set mode can be not used. Also the
setting is changed to “No” obligatory and
stored to EEPROM. If you press the [Mode
2] at Screen 10, IPC-2 pre-set mode can be
used and the setting number is stored to
EEPROM.
When you close the setup mode, go to 9 .
Screen 7
Screen 8
Screen 9
Panel/Host Set Ignore
No-Model Yes-Mode 2
Screen 10
Host Set Ignore
No-Model Yes-Mode 2
Screen 11