Filter
Top Products
M3099EX/EH OEM ManualB-10
<< SETUP MODE >>
RS232C BAUD
<< SETUP MODE >>
9600 : 4800 : 2400 : 1200
B3.10 Reset of endorser
When you reset the number to the initial number, you must see Section
A2.4 of Appendix A.
B3.11 Reset of ink counter
When you reset the ink counter, you must see Section A2.5 of Appendix A.
B3.12 Setting RS232C transfer rate
When you set the RS232C transfer rate, you must set as follows.
#1 At Screen 2, press [Mode 1] twelve tmies to
go to the RS232C BAUD screen. (Screen 23)
#2 Press [Mode 2] to see Screen 24. (The default
setting is 4800 bpsi)
#3 At Screen 24, press [Mode 1] until the value
you want to change blinks.
#4 Press [Mode 2] to see Screen 23. The settings
are stored to EEPROM.
#5 When you close the setup mode, go to 9.
B3.13 Setting picking start time
When you set the picking start time, you must set as follows.
#6 At Screen 2, press [Mode 1] thirteen times to
go to the PICK START TIME screen.
(Screen 25)
#7 Press [Mode 2] to see Screen 26. (The default
setting is 1 sec.)
#8 At Screen 26, press [Mode 1] until the digit
you want to change blinks. Then press [Mode
2] until the digit changes as you want. (The
specifiable range is from 0.2 to 29.8 sec. in
0.2 sec. step.)
Screen 23
Screen 24
<< SETUP MODE >>
PICK START TIMER
PICK START TIMER
X X . X S
Screen 26
Screen 25