Filter
Top Products
M3099EX/EH OEM Manual B-3
SETUP MODE
B3.1 Setting double-feed detection
When you set the using of double-feed detection, you must set as follows.
4 At Screen 2, press [Mode 1] once to go to the
DOUBLE FEED CHECK screen. (Screen 3)
5 Press [Mode 2] to see Screen 4. If “ON” is
displayed, the error will be detected when the
double-feed is occured. If “OFF” is displayed,
it wouldn’t. The “ON” or “OFF” status flips
each time you press [Mode 2].
6 Press [Mode 1] to see Screen 5. This means
how to defect the double-feed as follows.
“1” is the method by comparing with the
length of the first paper.
“2” is the method by the output of
Document detection sensor in addition to
“1”.
At Screen 5, press the [Mode 2] until the
number changes as you want.
7 Press [Mode 1] to see Screen 6. This means
the length to compare with the paper based
on. If you choose “1” or “2” and set “15mm”,
the double-feed is detected when the scanned
paper length is 15mm longer than the first
paper.
At Screen 6, press the [Mode 2] until the
number changes as you want.
(You can choose 10, 15 or 20mm. The
default is 15mm.)
8 Press [Mode 1] and [Mode 2] at a time to see
Screen 3. The settings are stored to
EEPROM.
9 When you close the setup mode, press [Stop].
Then the readable screen is displayed.
<< SETUP MODE >>
DOUBLE FEED CHECK
DOUBLE FEED CHECK
OFF 1 15mm
Screen 4
Screen 3
DOUBLE FEED CHECK
OFF 1 15mm
DOUBLE FEED CHECK
OFF 1 15mm
Screen 6
Screen 5