Filter
Top Products
M3099EX/EH OEM Manual B-9
SETUP MODE
0 0 0 0 1 (1 page)
0 0 0 0 2 (2 pages)
::
↓↓
6 5 5 3 4 (65534 pages)
6 5 5 3 5 (65545 pages)
→
B3.8 Setting initial value of endorser
When you set the using of endorser and the initial number, you must see
Section A2.1 and A2.2 of Appendix A. The details are as follows.
• The using of Endorser (ON/OFF)
The default setting is “OFF” (Endorser is not used.)
• The initial number
The default setting is “00000”. The specifiable range is from 00000 to
65535.
NOTICE: If the specified value exceeds acceptable range, returning
to SETUP menu is failed.
<Method of Increment>
In case of the initial value is “00001”.
NOTICE: When it is not set “depending on operator panel” by
host, no blinking. (You can not change the setting.)
When the setting is set “ON” depending on operator panel the
direction of printing is 20 mm from read reference position.
B3.9 Setting reset method of endorser
When you set the reset method of endorser, you must see Section A2.3 of
Appendix A.
The default setting is “ON” (The print number will be reset when
HOPPER EMPTY is detected.).