100 Operating manual RX600 S4
Hot-plug components CSS components
Removing expansion card from the removal tool
V CAUTION!
When removing the expansion card from the removal tool, pay particular
attention to the engaging hooks that fasten the board to the removal tool
(see figure 32 on page 100). Do not lift them by more than approx. 1 mm,
in other words only as far until the expansion card is released. Otherwise
you could damage the engaging hooks.
Figure 32: Removing the expansion card from the removal tool
Ê Lift the green movable engaging hooks no more than approx. 1 mm (1)
until the expansion card is completely released.
Ê Take the expansion card out (2) and put it aside.
2
1
1