Filter
Top Products
68 Operating manual RX600 S4
Switching the server on and off Starting up and operation
Switching the server off
The power-on indicator lights up green (item 6 in figure 13 on page 55).
Ê Shut down the operating system properly.
The server is switched off automatically and goes into standby mode. The
power-on indicator lights up orange.
I If the operating system does not switch the server off automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal.
Other On/Off options
Besides the On/Off button, the server can be switched ON and OFF in the
following ways:
– Specified switch-on time/switch-off time
The server is switched ON or OFF at a time specified in the ServerView
program
– Ring Indicator
The server is switched on by an internal or external modem.
– Wake On LAN (WOL)
The server is switched on by a command via the LAN (Magic Packet).
– After power failure
The server automatically reboots following a power failure (depending of the
settings in the BIOS).
– Power button override
The server can be switched off immediately by pressing and holding the
On/Off button (approx. 4-5 sec.).
V CAUTION!
There is a risk that data may be lost.
– IPMI
The server is switched on from an IPMI console (via the COM1 serial
interface or the RJ45 LAN interface).