Filter
Top Products
104 Operating manual RX600 S4
Hot-plug components CSS components
Ê Insert the green engaging hooks in the rods and push them down until they
engage in the upper edge of the expansion card.
V CAUTION!
Make sure that the ports on the expansion card are not blocked by the
engaging hooks.
Operating the expansion card
Ê Insert the expansion card fastened to the removal tool in the PCI slot.
Ê Close the slot lock (2) (see figure 31 on page 99) by folding it down. Make
sure that the slot lock engages.
Ê If necessary, connect the cables on the expansion card.
Ê Activate the expansion card using either the relevant PCI hot-plug software
or by pressing the optical waveguide (1, see figure 31 on page 99).
The optical waveguide flashes green. The slot is in an enable sequence.
Ê Wait until the optical waveguide is constantly green.
The slot is now powered on.
I If the optical waveguide continues to flash, an error has occurred.
Remove the expansion card and repeat the procedure as described
above.
Ê Close the housing cover (see “Opening/closing the housing” on page 114).