Filter
Top Products
102 Operating manual RX600 S4
Hot-plug components CSS components
8.1.5.2 Removing a dummy module
If a slot does not contain an expansion card, it is occupied by a dummy module.
This is a retaining plate with an attached removal tool.
Before inserting an additional hot-plug expansion card, you will first have to
remove the dummy module from its slot.
Ê Remove the housing cover (see “Opening/closing the housing” on
page 114).
Ê Remove the dummy module in the same way as a PCI board (see figure 32
on page 100).
Removing the retaining plate from the removal tool
Figure 34: Removing the retaining plate from the removal tool
V CAUTION!
When removing the retraining plate from the removal tool, pay particular
attention to the engaging hooks that fasten it to the removal tool. Never
lift the engaging hooks by more than approx. 1 mm, in other words only
as far until the retaining plate is released. Otherwise you could damage
the engaging hooks.
Ê Lift the green engaging hooks no more than approx. 1 mm (1) until the
retaining plate is released.
Ê Take the retaining plate out (2) and put it aside.
2
1
1