Hasselblad 70480533 Digital Camera User Manual


  Open as PDF
of 140
 
30
H4D
Attachingandremovingtheviewnder 1
While holding the viewnder at a slight angle and resting it on the top of the camera,
slide the viewnder forward until the front locating pin is in position in the recess in the
front edge of the viewnder screen aperture on camera body. Press the rear part of the
viewnder rmly downwards until it clicks into place.
Ensure that both sides of the viewnder are seated correctly and that it has been rmly
attached and locked into position. Failure to do so could cause an intermittent malfunc-
tion if the databus interface connections between the viewnder and camera body are
not positively secured.
To remove, grasp the viewnder in the right hand and while depressing the viewnder
release button, lift the rear of the viewnder up and away from the camera body.
Eyepiece adjustment 2
No corrective lenses are needed to adjust the eyepiece to suit most requirements. The
diopter range is from -5 to +3.5D. Eyeglass wearers can rapidly and accurately change
the settings according to whether they wish to wear eyeglasses for viewing or not.
Personal eyepiece adjustments can be carried out by pointing the camera at the sky or
similar smoothly toned area. While holding the camera in your left hand, you can with
your right thumb turn the adjustment wheel until the markings on the viewnder screen
reach the optimum sharpness for your eyesight.
If you normally wear eyeglasses for distance viewing and intend to wear them for camera
use then do not remove them for the above procedure. If, on the other hand, you prefer
to remove your eyeglasses for camera work, then repeat the above procedure without
wearing your eyeglasses.
Rubbereyecup
Two rubber eye cups are available for the H4D. The one supplied is suitable for users who
do not intend to use eyeglasses when photographing. The second shorter eye cup is for
those who either prefer to position their eye further from the viewnder and those who
wish to wear eyeglasses.
The eye cups can be rapidly changed by a Hasselblad Authorized Service Center.
Integral ash unit
See section on Flash for full details .
2
1
1
2
Parts and components HVD 90x & HV 90x-II
Note
There are two dierent viewnder
models. The HVD 90x is for 36x48mm
sensors (or smaller) cameras. The HV
90x-II is for the H4D-60.
User functions are the same for both
models.
A B C D E F G H
G. Flash unit release button
H. Viewnder release button
A. Rubber eye cup
B. Hot shoe
C. Eyesight adjustment wheel
D. Exposure compensation button
E. Exposure method / mode button
F. Integral ash unit
 previous next