Filter
Top Products
Use this option when you have only one drive
partition
.
b.
Restore the C: and D: partition
Use this option when you have only two drive partitions.
Note:
If you have more than two partitions, refer to the Microsoft documentation for
Disk
Management
.
4.
In
Step 2
, select the backup file from the list or
Browse
for the backup file. Drive backup files have
a
.npf
file extension.
Note:
The backup file may be split into multiple files. Select the
file with
001 in the name.
hp
-
0b343d9aeba9_C_Drive_01
-
04
-
2207_12
-
54
-
27PM.NPF
hp
-
0b343d9aeba9_C_Drive_01
-
04
-
2207_12
-
54
-
27PM_001.NPF
hp
-
0b343d9aeba9_C_Drive_01
-
04
-
2207_12
-
54
-
27PM_002.NPF
5.
In
Step 3
, select the drive you want to restore.
When restoring a hard drive, any content that exists on the target hard drive or drive partition will
be erased.
Note:
To exit
NTI DriveBackup!
before starting your restore, click
Job
,
Exit
.
6. Click
Start
.
Note:
If you want to exit the restore after clicking start, click the
Cancel
button.
To verify
proper disk operation, NTI DriveBackup! runs the Windows chkdisk utility when the system is
rebooted on restored drives with NTSF files system.
The target partition may be larger than the original partition where desired. You cannot select a partition
that is smaller than the amount of data on the original partition. In some cases, such as Windows 2000,
Service Pack 2, you may need select a target partition that is the same size as the original partition.