Filter
Top Products
How to install and remove internal hard drive
from your HP Media Vault
The HP Media Vault
’
s primary system hard disk uses the
Serial ATA
(SATA) interface. The internal expansion bay
will accommodate a second SATA disk. (The media vault does not support adding Integrated
Drive Electronics
(IDE) disks.)
You cannot remove or add a hard disk to the media vault while it is powered on and running.
To add a SATA disk into the expansion slot:
1.
Power down the media vault by pressing the power button on the front of the media vault and wait until it
completely shuts down.
2.
Open the front left door of the media vault.
3.
Turn the security knob on the hard drive tray counter
-
clockwise.
4.
Lift the drive tray handle out and gently pull the hard drive tray out of the expansion bay.