Filter
Top Products
14-2 PCL Rectangular Area Fill Graphics EN
3 Specify width of rectangle (Horizontal Rectangle Size Command -
Decipoints=
E
C
*c#H, or PCL Units=
E
C
*c#A).
4 Specify height of rectangle (Vertical Rectangle Size Command -
Decipoints=
E
C
*c#V, or PCL Units=
E
C
*c#B).
5 Select specific shade, cross-hatch, or user-defined pattern
(Pattern ID Command -
E
C
*c#G - Chapter 13)
1
.
6 Fill rectangular area with pattern (Fill Rectangular Area
Command -
E
C
c#P).
1
This ends the procedure and prints the
patterned area.
Note An area’s width extends in the positive X-direction of the PCL
coordinate system, and the height extends in the positive Y-direction.
The Pattern Transparency Mode controls how a pattern fills a
rectangular area. Pattern Transparency Mode determines what
effect transparent or opaque) the white pixels of the pattern have
on the rectangular area (refer to “Pattern Transparency Mode
Command” in Chapter 13).
1. White (1), black (0) or current (5) pattern also can be specified using this
command.